HAND TOOLS - Loppers

Felco 21" Lopper Parts

PLEASE VISIT OUR PAGE ON SMALL ORDERS BEFORE CHOOSING PARTS

Felco 21" Replacement Cutting Blade: The Felco replacement cutting blade for the Felco 21" lopper is shown here. It is the same blade that is used on the Felco 17" & Felco 25" loppers. To learn how to replace the blade click here. Although the tutorial is aimed at the hand pruners the same steps apply to loppers which are in fact just larger two handed versions of a small hand prunerMacromedia Flash might be required to view it.

Felco 21" Anvil Replacement The Felco anvil replacement blade for the Felco 21" lopper is shown here. It can only be used on a Felco 25" and 17" lopper . To learn how to replace the blade click here. Macromedia Flash might be required to view it.

Felco Replacement Grips Occasionally over time you might want to replace the plastic handles to renew your lopper. These plastic coated grips will fit any of the Felco loppers. Please note they are priced by the each.

Felco Handle w/Plastic Coating and Shock Absorber Sometimes some of our customers push the lopper a bit too far and the handles can bend or break. We have even seen some that have been run over by a car. The customer popped one of these new handles back on the lopper and it was as good as new. Please note that none of the handles are interchangable with other Felco loppers (it's the length)

Felco Support Pin This pin will work with the Felco 17", 21" & 25" Felco lopper

Hexagon Screw This hexagon screw will work with the Felco 17", 21" & 25" Felco loppers

Nut for Hexagon Screw This screw matches the hexagon screw listed above and will work with the Felco 17", 21" & 25" Felco loppers

Lopper Center Bolt This lopper center bolt will work with all the Felco loppers

Nut for Center Bolt This center bolt nut is a match to the center bolt listed above and will work with all the Felco loppers. It is advantageous to have a Felco adjustment key listed below when tightening this nut.

Shock Absorber This is an item that you might replace more often depending upon how often you use your lopper. The shock absorber job is to make it more comfortable to use. If after time you have lost that comfort it is time to replace them. These shock absorbers will work on any Felco lopper. Note these are priced by the each. It would be advisable to order two and replace both at the same time

Screw for Locking Segment This screw matches up with the locking segment shown below. The screw works with all the Felco loppers.

Locking Segment This locking segment is a match to the screw listed above and will work with all the Felco loppers. It is advantageous to have a Felco adjustment key listed below when tightening this nut.

Felco Adjustment Key The Felco adjustment key allows for accurate spot adjustment of blades. The hexagonal cut ours on the spaner enable all screws on the Felco loppers to be tightened and released if necessary.

Review your Purchases;	Continue Shopping;	Secure Checkout;
Shipping Options  |   Payment Options  |   E-Mail Info  |
Copyright and disclaimer © 1996-2006, FGS., Inc.